Every furnace call starts with a combustion and carbon monoxide safety check, not just a symptom fix.
Flat-rate pricing quoted after diagnosis, no pressure toward a premature system replacement.
If you're dealing with a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air, you already know furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other HVAC repairs don't, so the diagnostic has to start there.

Waiting rarely saves money and often turns a same-day repair into a longer, more involved job.
Our technicians treat every furnace repair call in Mequon, WI the same way, whether it's a straightforward fix or a stubborn intermittent fault that two other companies already missed.
We're licensed, insured, and staffed with techs who've spent years specifically on furnace repair, not general handyman work with an HVAC certificate bolted on.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
No push toward replacement when a repair genuinely solves the problem.
We understand a dead furnace in winter is a pipe-freezing risk, not just a comfort issue.
From the first symptom to the final fix, these are the specific furnace repair services our Mequon-area crews are equipped for.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. Techs handling ignitor & pilot light repair carry the specific parts and tools this job calls for, not a generic kit.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. This is one of the most requested furnace repair calls we get across Mequon, WI.
We use a combustion analyzer and visual borescope inspection, not guesswork. This is one of the most requested furnace repair calls we get across Mequon, WI.
We test motor amp draw against rated spec before replacement. This is one of the most requested furnace repair calls we get across Mequon, WI.
Blocked or improperly sloped venting can back-draft combustion gases into the home. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
We test low-voltage circuits before condemning the board. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Gas odor reports get immediate safety instructions before dispatch details.
We confirm your Mequon address and a realistic arrival window.
Safety check first — combustion and carbon monoxide — then full mechanical diagnostics.
Most ignition and control repairs finish same-visit.

Tech tested the ignitor's resistance right in front of me and swapped it in under thirty minutes.
Turned out to be a failed gas valve — they caught it with a proper pressure test, not a guess.
They found a hairline crack in the heat exchanger I never would've noticed.
Pilot light kept going out every few hours.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
Could be a delayed ignition fault, a failed gas valve, or a limit switch issue — a full diagnostic narrows it down.
Electric resistance furnaces fail differently than gas units, and we diagnose accordingly.
Gas odor calls receive top dispatch priority.
No-heat calls during freeze warnings are prioritized across Mequon, WI.

Whether you're in the heart of Mequon or one of the surrounding communities, dispatch routes the closest available technician.
☎ Call +1-866-805-8548 for Mequon Service